Miproglass 201 SV (Glass Flake Filled Lining)

A series of intermediate to heavy duty linings (or coatings) which can be applied to steel and concrete, to offer long term protection against corrosion and physical abuse. These systems consist of a toweled applied base coat over a primer coat and followed by glass flake filled top coats to achieve excellent chemical resistance, exceptionally low permeation and high physical properties for over all performance of lining & coating. Available in Isophthalic polyester, Bisphenol polyester, Vinyl Ester, Superior Vinyl Ester, Epoxy, Hybrid Epoxy resin system. Each of the MIPROGLASS 201 linings is reinforced with glass flakes up to 0.4mm (1/64 inch) in maximum Dimension by 3-4 microns thick, which lie parallel to the substrate thereby offering excellent resistance to permeation, corrosion, abrasion, physical abuse and thermal shock. MIPROGLASS 201 SV series coatings will withstand total immersion at temperatures up to 70 C, and gas temperatures up to 150 C. The recommended thickness of the MIPROGLASS 201 SV linings is 1mm to 3mm and this is obtained in two or more coats by trowel application. Plus Top coat by brush, roller or air less spray. Glass matt/cloth reinforcement is also possible for higher strength.

APPLICATION

Please request Surface Preparation and Installation Data sheets for specific advice.

CHEMICAL RESISTANCE

For information on the chemical resistance of each of these grades please contact CHEMIPROTECT ENGINEERS Corrosion Resistance Guide, under the appropriate code letter.

CURE

Cure times will vary with ambient temperatures and quantity of catalyst used. Typically the MIPROGLASS 201 SV series can be over coated within 4 to 6 hours and are hard in 8 to 12 hours. The coating will not be fully cured until about 72 hours after application but can go into light duty service after 24 hours.